Dra. Azócar-Ulloa, Laura

Nowadays, leaves, bark, and branches are generated from the tree-pruning process in urban places, where their management is a problem because of the necessity of disposal. These wastes are lignocellulosic biomasses with poor properties for use in biofuel production, but with interesting projections for building block products such as phenol compounds. Therefore, extensive biomass characterization of urban pruning from Liquidambar styraciflua L. was developed to evaluate its composition as a tool for phenol production through thermal processing, in which solvent extraction is a complementary tool for selectivity improvement. The results showed high lignin content in bark and leaves at 45 and 28 %, respectively, compared with that in branches (14 %). Additionally, high extractives in leaves (14 %) could be an additional source of phenols. The lignin units were analyzed by Raman dispersion, revealing p–hydroxyphenyl (H) units in the bark, guaiacyl (G) units in the bark and leaves, and syringyl (S) units only in the branches. Furthermore, the micropyrolysis coupled with gas chromatography/mass spectrometry assay realized at 600 ◦C showed high presence of phenolic compounds in the three biomass investigated, where a high phenol concentration was identified in leaves, probably due to the S unit degradation during pyrolysis. With these results, an assay for bio-oil production was performed in a low-temperature pyrolysis reactor using leaves as feedstock, reaching a low bio-oil yield with high water content favored for the high inorganic content of leaves (13 %). The produced bio-oil was used for liquid–liquid extraction evaluation, where 1-octanol and methyl isobutyl ketone were identified as interesting solvents for catechol and phenol extraction, respectively. This article presents the challenge of characterizing each part of urban trees, which could be a tool to promote the use of urban pruning by studying the thermal degradation mechanism to implement processes for high-value products, such as phenols produced from L. styraciflua L.

A Biomass Quality Index (BQI) developed using a previously reported tool was shown to be a promising method to rank biomass suitable for solid biofuel production. The BQI was developed by selecting 12 chemical parameters to be analyzed among ten available biomasses produced in the north, central and south of Chile. Furthermore, a Parameter Quality Index (PQI) was calculated to estimate the contribution of each parameter in the BQI. The sum of all PQIs for each biomass allowed the BQI to be determined, and biomasses with lower BQIs were more highly ranked. The results showed that the first 3 ranks were dominated by biomasses collected in central Chile, hazelnut shell, cherry pits and corn cobs (BQI ≤ 16.1). Furthermore, a promising candidate that was ranked fourth place was wheat straw (BQI = 17.7), which may be able to be used the highly polluted southern zone. Meanwhile, grass and the microalgae N. gaditana were ranked last (BQI ≥ 69.5). The low BQI obtained for the studied biomasses were related to their low PQIs regarding moisture content, low trace element content, low ash percentage and high carbon content and HHV. By contrast, high BQI values were related to high PQIs for moisture, Cl, Na and K content. K had a high contribution and Cu had a low contribution in the index. Due to the difficulty of milling the top ranked biomass, further studies should include a grindability analysis orother physical parameters to complete the BQI methodology.