Dr. Ulloa-Diaz, David

Throwing velocity is one of the most important factors for scoring goals in handball. This study aimed to identify the type of throw and procedure for selecting the final test outcome that provide throwing velocity with the greatest reliability. Fifteen experienced handball players and 33 non-experienced participants were tested in two sessions. Each session consisted of 4 trials of 3 different throwing tests (unspecific, 7-meters, and 3-steps). The maximum value of 4 trials, average value of 4 trials, and average value of the 3 best trials were considered. Throwing velocity was highly reliable (coefficient of variation [CV]≤3.3%, intraclass correlation coefficient≥0.89) with the exception of the unspecific throw for the non-experienced group (CV≥5.9%, intraclass correlation coefficient≤0.56). The 3-steps throw (CV=1.7%) was more reliable than the 7-meters throw (CV=2.1%) (CVratio=1.19) and unspecific throw (CV = 3.8%) (CVratio=2.18), the 3 procedures provided a comparable reliability (CV range=2.4−2.6%; CVratio≤1.07), and the experienced group (CV=1.0%) presented a higher reliability than the non-experienced group (CV=4.0%) (CVratio=3.83). These results support the 3-steps throw to maximise the reliability of throwing velocity performance.

This study examined the reliability and validity of three methods of estimating the one-repetition maximum (1RM) during the free-weight prone bench pull exercise. Twenty-six men (22 rowers and four weightlifters) performed an incremental loading test until reaching their 1RM, followed by a set of repetitions-to-failure. Eighteen participants were re-tested to conduct the reliability analysis. The 1RM was estimated through the lifts-to-failure equations proposed by Lombardi and O'Connor, general load-velocity (L-V) relationships proposed by Sánchez-Medina and Loturco and the individual L-V relationships modelled using four (multiple-point method) or only two loads (two-point method). The direct method provided the highest reliability (coefficient of variation [CV] = 2.45% and intraclass correlation coefficient [ICC] = 0.97), followed by the Lombardi's equation (CV = 3.44% and ICC = 0.94), and no meaningful differences were observed between the remaining methods (CV range = 4.95-6.89% and ICC range = 0.81-0.91). The lifts-to-failure equations overestimated the 1RM (3.43-4.08%), the general L-V relationship proposed by Sánchez-Medina underestimated the 1RM (-3.77%), and no significant differences were observed for the remaining prediction methods (-0.40-0.86%). The individual L-V relationship could be recommended as the most accurate method for predicting the 1RM during the free-weight prone bench pull exercise.