Dr. Muñoz-Ortiz, Enrique

The use of unmanned aerial vehicles (UAVs) is steadily increasing due to their capacity to capture terrain elevation data with remarkable precision and cost-effectiveness. Nonetheless, their application for estimating water surface elevations and submerged terrain, such as channel bathymetry, remains constrained. Consequently, the development of a digital terrain model that relies on UAV data during low-water periods assumes a more extensive dry channel surface area, thus alleviating the information gap regarding submerged terrain. The objective of this brief report is to validate a hydraulic model for flood calculation. To this end, a 1D steady-state hydrological model of the Ñuble River based on a UAV survey in the low-water period of 2016 was constructed in HEC-RAS v.5.0.3 and compared to water surface elevation observations of the flood on 24 June 2023. The model tends to overestimate the flood, but the errors are considered tolerable for flood calculation (on average, a 10.6% depth error was obtained for a 30-year return period flood); therefore, the hydraulic model derived from remote sensing seems to be an effective alternative for the construction of hydraulic models for flood studies.

The use of unmanned aerial vehicles (UAVs) has been steadily increasing due to their ability to acquire high-precision ground elevation information at a low cost. However, these devices have limitations in estimating elevations of the water surface and submerged terrain (i.e., channel bathymetry). Therefore, the creation of a digital terrain model (DTM) using UAVs in low-water periods means a greater dry channel surface area and thus reduces the lack of information on the wet area not appropriately measured by the UAV. Under such scenarios, UAV-DTM-derived data present an opportunity for practical engineering in estimating floods; however, the accuracy of estimations against current methods of flood estimations and design needs to be measured. The objective of this study is therefore to develop an exploratory analysis for the creation of hydraulic models of river floods using only UAV-derived topographic information. Hydraulic models were constructed based on DTMs created in (i) the traditional manner, considering the bathymetry measured with RTK-GPS and topography, and via (ii) remote sensing, which involves topography measurement with a UAV and assumes a flat bed in the part of the channel covered by water. The 1D steady-state HEC-RAS model v.5.0.3 was used to simulate floods at different return periods. The applied methodology allows a slightly conservative, efficient, economical, and safe approach for the estimation of floods in rivers, with an RMSE of 6.1, 11.8 and 12.6 cm for the Nicodahue, Bellavista and Curanilahue rivers. The approach has important implications for flood studies, as larger areas can be surveyed, and cost-and time-efficient flood estimations can be performed using affordable UAVs. Further research on this topic is necessary to estimate the limitations and precision in rivers with different morphologies and under different geographical contexts.