Dr. Sanhueza-Espinoza, Frank

An improved numerical formulation for a self-centering frictional damper is presented. This was experimentally validated through quasi-static tests carried out on a steel-made prototype of the damper. Its design is ad hoc for implementation in the seismic protection of industrial storage racks. The conceptual model of the device was adjusted to the prototype built. The formulation of the analytical model, a parametric analysis of it, and the validation with experimental results are presented. The improvement of the model presented here explicitly considers elements included in the prototype, such as a system of load transmission rings and the friction between all of the components that slide or rotate relatively. In the experimental validation, the parameters of the improved model were determined. The numerical predictions for the improved model were contrasted with those obtained with the original one and with the experimental results. This demonstrates that the improvement leads to a better adjustment of the numerical predictions concerning the experimental measurements, which is useful for nonlinear analysis. The device withstood forces of considerable magnitude in addition to dissipating enough energy per load–unload cycle to be effective in the seismic protection of industrial storage racks.

This research evaluates the effectiveness of using a roller-type base isolation device with tensile strength in reducing the dynamic response of industrial steel storage racks. These were subjected to a seismic input acting separately in both directions of the structure. The seismic record obtained from the earthquake that occurred in Llolleo, Chile, on 3 March 1985, was used as input. This earthquake was scaled in the frequency domain, adjusting its response spectrum to coincide with the design spectrum required by NCh2745. In the calculations of this spectrum, the most hazardous seismic zone (zone 3) and soft soil (soil III) that amplifies the effect of the low frequencies of the earthquake were considered. These frequencies are the ones that have the most affect on flexible structures such as high racks and systems with base isolation. Numerical time-history analyses were performed in fixed base racks and base isolation racks. In both cases, the models include semi-rigid connections with capacity for plastic deformation and energy dissipation. Parametric analyses were carried out considering the most relevant variables, using an algorithm programmed in MATLAB software. The maximum relative displacement, maximum basal shear load, and maximum absolute floor acceleration were considered as responses of interest. The results showed the effectiveness of using the base isolation device by reducing the absolute accelerations between approximately 75% and 90%, compared to the same fixed rack at its base. This makes it possible to reduce the vulnerability of the stored load to overturn under the action of a severe earthquake.