Dr. Valdes-Morales, Hector

Anatase nanoparticles containing surface oxygen vacancies (VO) and Ti3+ are of great importance for applications in photocatalysis, batteries, catalysis, sensors among other uses. The properties of VO and their dependence on the size of nanoparticles are of great research interest and could allow obtaining advanced functional materials. In this work, a complete set of oxygen vacancies in an anatase nanoparticle of size 1.1 nm was investigated and compared to those of a twice larger nanoparticle, having the same shape and surface hydroxylation pattern. It turned out that the decrease in the size of the anatase nanoparticle strongly facilitated creation of surface oxygen vacancies and Ti3+. After their creation, oxygen vacancies undergo three transformation paths — (1) small repulsion of surrounding Ti cations with retention of the vacancy, (2) transfer of oxygen anion, leading to the movement of oxygen vacancy to a more stable position, and (3) collapse of oxygen vacancy accompanied by structure deformation towards Magneli-like phase.

Zeolites are widely used for numerous processes for production of a vast number of chemicals, fuels and commercial goods. Preparation of zeolite catalysts that have improved selectivity for the desired products, operate at lower temperature and possess increased stability is therefore of great interest. The key to such improved zeolite catalysts is in the design of active sites and facilitation of mass transfer via optimization of the porous structure. At the same time, undesirable sites that inhibit desirable properties of the active sites need to be removed or blocked. The strength and structure of either the Brønsted or Lewis acid sites, directly determines their catalytic activity and selectivity for each reaction. In the present study, the structure and acidity of active sites in zeolites are investigated for the example of mordenite using modern semiempirical methods pm7 and scc-dftb (dftb2). Models AlHSi95O192 and Al2H2Si94O192 are used for Brønsted acid sites and Al2Si94O191 for Lewis acid sites. In agreement with previous studies, the stability of T1, T2, T3 and T4 sites is similar. Many different configurations of pair-wise located Al atoms were studied. In the present work it was found that some of the pair-wise located Al atoms possess Brønsted acid sites with strength much higher than that for single Brønsted acid sites. However, since their stability is not the highest among other double sites, special preparation methods need to be developed for selectively obtaining these very active sites. The stability of different Lewis acid sites is also considered.

Anatase (001)nanosheets have recently attracted great attention as very active catalysts and photocatalysts. These graphene analogs have very high surface area and unique surface properties. In the present paper, very thin two-layer anatase nanosheets are investigated computationally in the form of quantum dots of various size. Quantum size effect (QSE)was clearly observed for nanosheets with fully hydroxylated edges and size up to 14 nm and the ultimate band gap is around 3.4 eV. Dehydroxylation of nanosheets obscured QSE, decreased band gap and induced visible light absorption. Therefore, contradictory trends reported in experimental studies for anatase QSE can be ascribed to different degree of hydroxylation of the TiO 2 samples surface. All anatase nanosheet quantum dots retained their flat graphene-like shape. These findings demonstrate that dehydroxylated anatase nanosheet quantum dots are prospective visible-light active photocatalysts even if their inherent band gap is considerably larger than for bulk anatase.

A facile combined method, namely sonothermal-hydrothermal, was adopted to assemble titanium dioxide (TiO2) nanoparticles on the surface of reduced graphene oxide (RGO) to form nanocomposites. Characterization techniques confirm that RGO-TiO2 composite is well constituted. Enhanced photocatalytic CO2 reduction to methanol by the composites under UVA and visible irradiation suggests the modification in the band gap of the composite and promotion of the separation of photogenerated carriers, yielding methanol production rate of 2.33 mmol g−1 h−1. Theoretical investigation demonstrated that combining RGO with TiO2 resulted in an upward shift of TiO2 bands by 0.2 V due to the contribution of RGO electrons. Relatively strong adsorption of RGO over the (101) anatase surface with the binding energy of approximately 0.4 kcal mol−1 per carbon atom was observed. Consideration of orbitals of TiO2, RGO and RGO-TiO2 composite led to a conclusion that UVA photoreaction proceeds via the traditional mechanism of photogenerated electron transfer to RGO while visible light CO2 reduction proceeds as a result of charge transfer photoexcitation that directly produces electrons in RGO and holes in TiO2. Superior photocatalytic activity of RGO-TiO2 composite in the present study is attributed to the formation of tight contact between its constituents, which is required for efficient electron and charge transfer.

Cationic doping of TiO2 anatase with sulphur represents a facile method to improve catalytic and photocatalytic activity for hydrogen production and extend the action spectrum of TiO2 into the visible light region. However, there is a lot of misunderstanding when trying to explain the experimental findings and suggest theoretical models. In the present computational research work, novel theoretical models are put forward representing fully hydroxylated small anatase nanoparticles with S(IV) and S(VI) doping in various surface positions and in the bulk. It was found that sulfur in the doped anatase nanoparticles preserves its typical coordination geometries of trigonal pyramid for S(IV) and tetrahedron for S(VI). Doping in the anatase surface is much more energetically favorable compared to doping in the bulk. Doping with S(IV) causes decrease of the band gap from 3.22 to 2.65 eV while S(VI) doping could decrease Eg only to 2.96 eV. Location of photogenerated electrons and holes depends strongly on the position of dopant atoms and their valent state. Contrary to some experimental works, no strong and extended visible light absorption bands could be found with cationic doped hydroxylated anatase nanoparticles. However, improved charges separation is observed indeed and causes improved photocatalytic hydrogen production.